Support QRP CoA Everywhere

Friday 7 September 2018

Dual Hotends on K8200

Going to see what this looks like on the old K8200 3D Printer a Chimera V6 dual head with remote bowden titans extruders will set it up for 3mm and 1.75mm. I have a feeling I might try some PVA dissolving filament as support material.  

0.2mm,0.3mm, 0.4mm and 0.5mm Nozzles for 1.75mm filament, also have some 1mm and 1.5mm for 3mm filament. Looks like the heaters can be either 12V or 24V and the thermistors are standard 100K NTC glass bead type.

I'll add a pair of silicon J6 clone socks to them as well so can differentiate between them.

The mount will almost certainly be an aluminum plate or 3D printeted backet.

Looks like RAMPS1.4 will happily accommodate the extra extruder and hot end.

The filament run out sensors will also be separate, not sure can have on both but will investigate.

No comments: