image for profile

MD1K in IOTA contest

Yes will be active from EU-116 in RSGB IOTA contest.

The webcams are offline for moment though.

router table

Just cut bits for router table for the 710w trim router. 24"*18", A 3" offset and 3" fence. Might cut T slots for 3/8"bolts but clamps work. All imperial sorry but have scribbled some cm measurements on the board. It it 3/4" ply (c18mm). 3" offset as have to put edges on some 15" wide board and 9" didn't feel like enough to support. I will add feather boards, some steel rulers sunk into the table and vacuum line.

It will sit on a workmate clone, the lift will be a 1 ton car jack.

The router base I will set into the table for now, I have ordered an aluminium router plate that will make fitting etc so much simpler.

but not shown up yet so will proceed without it for the moment. 

The horizontal square slot is for the edge trim height adjustment tool.

It arrived.

 

You are looking at the base the top is a much better finish, but will coat it with several layers of polyurethane varnish.

As well as what it is actually for I guess I will be remaking some shack PSU enclosures.