Support QRP CoA Everywhere

Sunday 12 August 2018

3mm under Z switch

Photo says it all. Everyone has some HSS drills this packet has nice handy dimensions on the pack too so you know what size you have used, although every drill bit will have it stamped on too.

Place a twist drill bit under the switch mount and then move the extruder mount GENTLY down (I did it manually with the steppers disengaged) and tighten in place so you can just remove the drill bit. Result is Z limit switch is c3mm higher.


You can tell it to move home and you'll see it will now be 3mm higher.

No comments: