Just putting in some mounts to put up the RSGB IOTA antennas
That is the old pole and mast next to it, was on a wooden post.
The green/yellow wire goes to an extensive ground system.
6 foot scaffolding pole driven in about 3 feet. Pulled back the ground cover fabric, will replace after.
Rotator will go on a shorter pole driven right in and here it is being levelled up.
Rotator (RC5) in place.
Testing a 2" tube for fit.
Adding pole and checking for true.
Top, clears the tree :-)
That is the old pole and mast next to it, was on a wooden post.
The green/yellow wire goes to an extensive ground system.
6 foot scaffolding pole driven in about 3 feet. Pulled back the ground cover fabric, will replace after.
Rotator will go on a shorter pole driven right in and here it is being levelled up.
Rotator (RC5) in place.
Testing a 2" tube for fit.
Adding pole and checking for true.
Top, clears the tree :-)
Just checking how many ball bearings and fit on the 2" guy rings will use on this pole.
A DXhexbeam is the intended antenna.
No comments:
Post a Comment