QRPGuys UnUnPlus

One of the antennas for RSGB IOTA Contest as M1K from St Agnes EU011.

https://qrpguys.com/ununtenna-plus

The current build docs are here https://qrpguys.com/wp-content/uploads/2018/05/unun_plus_assy_051918.pdf

My build... will update as it goes.

Layout all the parts and check with the circuit diagram.

 I can see I have a spare capactor indicator plate but a missing 470ohm resistor. No harm got one in the 'junkbox'

Why do  some find some torroids so hard to wind?

The FT37-43 SWR indicator torroid is not hard.

Watch the orientation of the zip ties as you pass them through the board if you want them to sit flat.

C1 & C2 yes you have to modify, not hard just be really careful taking off the plastic. I use a little bench vice and hacksaw and just cut a couple of slots.

T1. I changed the provided tie wraps for green and orange ones but the provided ones are fine.

T2. again I changes the provided tie wraps for blue and yellow ones

There the kit ends so will have to add wires etc...

I suspect if gets wet might be fun so will craft a cover of sorts.